G-3000H User’s Guide

 

Figure 118 Menu 3.5.4 Bridge Link Configuration

 

 

 

 

 

Menu 3.5.4 - Bridge Link Configuration

 

Enable Link 1= Yes

Peer MAC Address= 0b:16:21:2c:37:45

 

PSK= ********

Peer MAC Address= 00:0b:16:2c:37:3d

 

Enable Link 2= No

 

PSK= ********

Peer MAC Address= 0b:16:21:2c:37:3e

 

Enable Link 3= Yes

 

PSK= ********

Peer MAC Address= 0b:16:21:2c:37:3f

 

Enable Link 4= No

 

PSK= ********

Peer MAC Address= 0b:16:21:2c:37:40

 

Enable Link 5= Yes

 

PSK= ********

 

 

 

Enable WDS Security= Yes

 

Press ENTER to Confirm or ESC to Cancel:

 

Press Space Bar to Toggle.

 

The following table describes the fields in this menu.

Table 68 Menu 3.5.4 Bridge Link Configuration

FIELD

DESCRIPTION

 

 

Enable Link 1 ~ 5

Press [SPACE BAR] to select Yes or No and press [ENTER].

 

 

Peer MAC Address

Type the MAC address of peer device in valid MAC address format, that is, six

 

hexadecimal character pairs, for example, 12:34:56:78:9a:bc.

PSK

Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including

 

spaces and symbols)

Enable WDS Security

Select Yes to enable WDS on your ZyAIR. A Wireless Distribution System

 

(WDS) is a wireless connection between two or more APs.

 

When you select Yes, you are prompted to type a Pre-Shared Key (PSK) in the

 

PSK fields of each bridge link you want to configure. The ZyAIR uses TKIP to

 

encrypt traffic on the WDS between AP’s.

 

Note: Other AP’s must use the same encryption method to

 

enable WDS.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

17.3.5 Configuring Layer-2 Isolation

Follow the steps below to configure layer-2 isolation on your ZyAIR.

1From the main menu, enter 3 to open Menu 3 – LAN Setup.

2Enter 5 to display Menu 3.5 – Wireless LAN Setup.

Chapter 17 LAN Setup

189