G-3000H User’s Guide

Figure 149 Menu 24.7.2 as seen using the Console Port

Menu 24.7.2 - System Maintenance - Upload System Configuration File

To upload system configuration file:

1.Enter "y" at the prompt below to go into debug mode.

2.Enter "atlc" after "Enter Debug Mode" message.

3.Wait for "Starting XMODEM upload" message before activating Xmodem upload on your terminal.

4.After successful firmware upload, enter "atgo" to restart the system.

Warning:

1.Proceeding with the upload will erase the current configuration file.

2.The system’s console port speed (Menu 24.2.2) may change when it is restarted; please adjust your terminal's speed accordingly. The password may change (menu 23), also.

3.When uploading the DEFAULT configuration file, the console

port speed will be reset to 9600 bps and the password to "1234".

Do You Wish To Proceed:(Y/N)

2After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your computer. Follow the procedure as shown previously for the HyperTerminal program. The procedure for other serial communications programs should be similar.

3Enter “atgo” to restart the ZyAIR.

23.4.10Example Xmodem Configuration Upload Using HyperTerminal

Click Transfer, then Send File to display the following screen.

Figure 150 Example Xmodem Upload

Type the configuration file’s location, or click Browse to search for it.

Choose the Xmodem protocol.

Then click Send.

After the configuration upload process has completed, restart the ZyAIR by entering “atgo”

218

Chapter 23 Firmware and Configuration File Maintenance