Figure 52 WAN Dial Backup Modem Setup
The following table describes the labels in this screen.
Table 29 WAN Dial Backup Modem Setup
LABEL | DESCRIPTION |
|
|
AT Command |
|
Strings |
|
Dial | Type the AT Command string to make a call. Example: atdt |
|
|
Drop | Type the AT Command string to drop a call. "~" represents a one second wait, for |
| example, "~~+++~~ath" can be used if your modem has a slow response time. |
Answer | Type the AT Command string to answer a call. Example: ata |
|
|
Drop DTR When | Select this check box to have the ZyXEL Device drop the DTR (Data Terminal |
Hang Up | Ready) signal after the "AT Command String: Drop" is sent out. |
AT Response |
|
Strings |
|
CLID | Type the keyword that precedes the CLID (Calling Line Identification) in the AT |
| response string. This lets the ZyXEL Device capture the CLID in the AT response |
| string that comes from the WAN device. CLID is required for CLID authentication. |
| Example: NMBR |
Called ID | Type the keyword preceding the dialed number. |
|
|
Speed | Type the keyword preceding the connection speed. Example: CONNECT |
|
|
Call Control |
|
|
|
Dial Timeout | Type a number of seconds for the ZyXEL Device to try to set up an outgoing call |
| before timing out (stopping). Example: 60 |
Retry Count | Type a number of times for the ZyXEL Device to retry a busy or |
| number before blacklisting the number. Example: 0 |
106 | Chapter 5 WAN Setup |