The following table describes the labels in this screen.
Table 15 Wireless LAN Setup Wizard 1
LABEL | DESCRIPTION |
|
|
Active | Select the check box to turn on the wireless LAN. |
| Note: You can also activate the wireless LAN by pressing the |
| RESET button for 1 second. |
Enable OTIST | Select the check box to enable OTIST if you want to transfer your ZyXEL |
| Device’s SSID and WEP or |
| support OTIST and are within transmission range. |
| You must also activate and start OTIST on the wireless client at the same time. |
| The process takes three minutes to complete. |
| Note: You can start OTIST by pressing the RESET button for 3 |
| seconds. |
Setup Key | Type an OTIST Setup Key of up to eight ASCII characters in length. Be sure to |
| use the same OTIST Setup Key on the ZyXEL Device and wireless clients. |
Back | Click Back to display the previous screen. |
|
|
Next | Click Next to proceed to the next screen. |
|
|
Exit | Click Exit to close the wizard screen without saving. |
3Configure your wireless settings in this screen. Click Next.
Figure 32 Wireless LAN Setup Wizard 2
74 | Chapter 3 Wizard Setup for Internet Access |