Figure 23 Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
Table 10 Internet Access Wizard Setup: ISP Parameters
LABEL | DESCRIPTION |
|
|
Mode | From the Mode |
| multiple computers to share an Internet account. Otherwise select Bridge. |
Encapsulation | Select the encapsulation type your ISP uses from the Encapsulation |
| box. Choices vary depending on what you select in the Mode field. |
| If you select Bridge in the Mode field, select either PPPoA or RFC 1483. |
| If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or |
| PPPoE. |
Multiplexing | Select the multiplexing method used by your ISP from the Multiplex |
| box either |
Virtual Circuit | VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit. |
ID | Refer to the appendix for more information. |
VPI | Enter the VPI assigned to you. This field may already be configured. |
|
|
VCI | Enter the VCI assigned to you. This field may already be configured. |
|
|
Back | Click Back to go back to the previous screen. |
|
|
Next | Click Next to continue to the next wizard screen. The next wizard screen you see |
| depends on what protocol you chose above. |
Exit | Click Exit to close the wizard screen without saving your changes. |
|
|
68 | Chapter 3 Wizard Setup for Internet Access |