To edit your ZyXEL Device's advanced WAN settings, click the Advanced Setup button in the More Connections Edit screen. The screen appears as shown.
Figure 47 More Connections Advanced Setup
The following table describes the labels in this screen.
Table 26 More Connections Advanced Setup
LABEL | DESCRIPTION |
|
|
RIP & Multicast |
|
Setup |
|
RIP Direction | Select the RIP direction from None, Both, In Only and Out Only. |
|
|
RIP Version | Select the RIP version from |
Multicast | IGMP (Internet Group Multicast Protocol) is a |
| establish membership in a multicast group. The ZyXEL Device supports both IGMP |
| version 1 |
ATM QoS |
|
|
|
ATM QoS Type | Select CBR (Continuous Bit Rate) to specify fixed |
| or data traffic. Select UBR (Unspecified Bit Rate) for applications that are |
| sensitive, such as |
| |
| other applications. |
Peak Cell Rate | Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak Cell |
| Rate (PCR). This is the maximum rate at which the sender can send cells. Type the |
| PCR here. |
Sustain Cell Rate | The Sustain Cell Rate (SCR) sets the average cell rate |
| transmitted. Type the SCR, which must be less than the PCR. Note that system |
| default is 0 cells/sec. |
Maximum Burst | Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent |
Size | at the peak rate. Type the MBS, which is less than 65535. |
Back | Click Back to return to the previous screen. |
|
|
98 | Chapter 5 WAN Setup |