P-662H/HW-D Series User’s Guide

 

Table 25 More Connections Edit (continued)

 

 

 

 

LABEL

DESCRIPTION

 

 

 

 

Multiplexing

Select the method of multiplexing used by your ISP from the drop-down list.

 

 

Choices are VC or LLC.

 

 

By prior agreement, a protocol is assigned a specific virtual circuit, for example,

 

 

VC1 will carry IP. If you select VC, specify separate VPI and VCI numbers for

 

 

each protocol.

 

 

For LLC-based multiplexing or PPP encapsulation, one VC carries multiple

 

 

protocols with protocol identifying information being contained in each packet

 

 

header. In this case, only one set of VPI and VCI numbers need be specified for

 

 

all protocols.

 

VPI

The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.

 

 

 

 

VCI

The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local

 

 

management of ATM traffic). Enter the VCI assigned to you.

 

IP Address

This option is available if you select Routing in the Mode field.

 

 

A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is

 

 

not fixed; the ISP assigns you a different one each time you connect to the

 

 

Internet.

 

 

If you use the encapsulation type except RFC 1483, select Obtain an IP

 

 

Address Automatically when you have a dynamic IP address; otherwise select

 

 

Static IP Address and type your ISP assigned IP address in the IP Address

 

 

field below.

 

 

If you use RFC 1483, enter the IP address given by your ISP in the IP Address

 

 

field.

 

Subnet Mask

Enter a subnet mask in dotted decimal notation.

 

 

Refer to the appendices to calculate a subnet mask If you are implementing

 

 

subnetting.

 

Gateway IP address

Specify a gateway IP address (supplied by your ISP).

 

 

 

 

Connection

 

 

 

 

 

Nailed-Up

Select Nailed-Up Connection when you want your connection up all the time.

 

Connection

The ZyXEL Device will try to bring up the connection automatically if it is

 

 

disconnected.

 

Connect on Demand

Select Connect on Demand when you don't want the connection up all the time

 

 

and specify an idle time-out in the Max Idle Timeout field.

 

Max Idle Timeout

Specify an idle time-out in the Max Idle Timeout field when you select Connect

 

 

on Demand. The default setting is 0, which means the Internet session will not

 

 

timeout.

 

NAT

SUA only is available only when you select Routing in the Mode field.

 

 

Select SUA Only if you have one public IP address and want to use NAT. Click

 

 

Edit to go to the Port Forwarding screen to edit a server mapping set.

 

 

Otherwise, select None to disable NAT.

 

 

 

 

Back

Click Back to return to the previous screen.

 

 

 

 

Apply

Click Apply to save the changes.

 

 

 

 

Cancel

Click Cancel to begin configuring this screen afresh.

 

 

 

 

Advanced Setup

Click this button to display the More Connections Advanced screen and edit

 

 

more details of your WAN setup.

Chapter 5 WAN Setup

97