21.9 TR-069
An administrator can use CNM Access to remotely set up the ZyXEL device, modify settings, perform firmware upgrades as well as monitor and diagnose the ZyXEL device. All you have to do is enable the device to be managed by CNM Access and specify the CNM Access IP address or domain name and username and password.
Follow the procedure below to configure your ZyXEL Device to be managed by CNM Access. See the Command Interpreter appendix for information on the command structure and how to access the CLI (Command Line Interface) on the ZyXEL Device.
Note: In this example a.b.c.d is the IP address of CNM Access. You must change this value to reflect your actual management server IP address or domain name. See Table 132 on page 319for detailed descriptions of the commands.
Figure 172 Enabling
ras> wan tr069 load
ras> wan tr069 acsUrl a.b.c.d
ras> wan tr069 informInterval 2400 TR069 Informinterval 2400
ras> wan tr069 active 1 ras> wan tr069 save
The following table gives a description of
Table 132
Root | Command or | Command | Description | |
Subdirectory | ||||
|
|
| ||
|
|
|
| |
wan | tr069 |
| All | |
|
| load | Start configuring | |
|
| active [0:no/ | Enable/disable | |
|
| 1:yes] |
| |
|
| acsUrl <URL> | Set the IP address or domain name of CNM Access. | |
|
| username | Username used to authenticate the device when making a | |
|
| [maxlength:15] | connection to CNM Access. This username is set up on the server | |
|
|
| and must be provided by the CNM Access administrator. | |
|
| password | Password used to authenticate the device when making a | |
|
| [maxlength:15] | connection to CNM Access. This password is set up on the server | |
|
|
| and must be provided by the CNM Access administrator. |
Chapter 21 Remote Management Configuration | 319 |