The following table describes the fields in this screen.
Table 12 Internet Connection with RFC 1483
LABEL | DESCRIPTION |
|
|
IP Address | This field is available if you select Routing in the Mode field. |
| Type your ISP assigned IP address in this field. |
|
|
Back | Click Back to go back to the previous wizard screen. |
|
|
Next | Click Next to continue to the next wizard screen. |
|
|
Exit | Click Exit to close the wizard screen without saving your changes. |
|
|
Figure 26 Internet Connection with ENET ENCAP
The following table describes the fields in this screen.
Table 13 Internet Connection with ENET ENCAP
LABEL | DESCRIPTION |
|
|
Obtain an IP | A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not |
Address | fixed; the ISP assigns you a different one each time you connect to the Internet. |
Automatically | Select Obtain an IP Address Automatically if you have a dynamic IP address. |
| |
|
|
Static IP | A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not |
Address | fixed; the ISP assigns you a different one each time you connect to the Internet. |
| Select Static IP Address if your ISP gives you a fixed IP address. |
|
|
IP Address | Enter your ISP assigned IP address. |
|
|
Subnet Mask | Enter a subnet mask in dotted decimal notation. |
| Refer to the appendices to calculate a subnet mask If you are implementing subnetting. |
|
|
Gateway IP | You must specify a gateway IP address (supplied by your ISP) when you use ENET |
address | ENCAP in the Encapsulation field in the previous screen. |
70 | Chapter 3 Wizard Setup for Internet Access |