P-662H/HW-D Series User’s Guide

Figure 56 Advanced LAN Setup

The following table describes the labels in this screen.

Table 31 Advanced LAN Setup

LABEL

DESCRIPTION

 

 

RIP & Multicast

 

Setup

 

RIP Direction

Select the RIP direction from None, Both, In Only and Out Only.

 

 

RIP Version

Select the RIP version from RIP-1, RIP-2Band RIP-2M.

 

 

Multicast

IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to

 

establish membership in a multicast group. The ZyXEL Device supports both IGMP

 

version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.

Any IP Setup

Select the Active check box to enable the Any IP feature. This allows a computer to

 

access the Internet without changing the network settings (such as IP address and

 

subnet mask) of the computer, even when the IP addresses of the computer and

 

the ZyXEL Device are not in the same subnet.

 

When you disable the Any IP feature, only computers with dynamic IP addresses or

 

static IP addresses in the same subnet as the ZyXEL Device’s LAN IP address can

 

connect to the ZyXEL Device or access the Internet through the ZyXEL Device.

Windows

NetBIOS (Network Basic Input/Output System) are TCP or UDP packets that

Networking

enable a computer to connect to and communicate with a LAN. For some dial-up

(NetBIOS over

services such as PPPoE or PPTP, NetBIOS packets cause unwanted calls.

TCP/IP)

However it may sometimes be necessary to allow NetBIOS packets to pass through

 

to the WAN in order to find a computer on the WAN.

Allow between

Select this check box to forward NetBIOS packets from the LAN to the WAN and

LAN and WAN

from the WAN to the LAN. If your firewall is enabled with the default policy set to

 

block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall

 

rule that forwards NetBIOS traffic.

 

Clear this check box to block all NetBIOS packets going from the LAN to the WAN

 

and from the WAN to the LAN.

Back

Click Back to return to the previous screen.

 

 

Apply

Click Apply to save the changes.

 

 

Cancel

Click Cancel to begin configuring this screen afresh.

 

 

116

Chapter 6 LAN Setup