Chapter 16 Log and Report

The following table describes the fields in this screen.

Table 86 Configuration > Log & Report > Log Setting > Active Log Summary

LABEL

DESCRIPTION

Active Log

If the NWA3000-N series AP is set to controller mode, the AC section

Summary

controls logs generated by the controller and the AP section controls logs

 

generated by the managed APs.

 

 

System log

Use the System Log drop-down list to change the log settings for all of

 

the log categories.

 

disable all logs (red X) - do not log any information for any category

 

for the system log or e-mail any logs to e-mail server 1 or 2.

 

enable normal logs (green check mark) - create log messages and

 

alerts for all categories for the system log. If e-mail server 1 or 2 also

 

has normal logs enabled, the NWA3000-N series AP will e-mail logs to

 

them.

 

enable normal logs and debug logs (yellow check mark) - create log

 

messages, alerts, and debugging information for all categories. The

 

NWA3000-N series AP does not e-mail debugging information, even if

 

this setting is selected.

 

 

E-mail Server

Use the E-Mail Server 1 drop-down list to change the settings for e-

1

mailing logs to e-mail server 1 for all log categories.

 

Using the System Log drop-down list to disable all logs overrides your

 

e-mail server 1 settings.

 

enable normal logs (green check mark) - e-mail log messages for all

 

categories to e-mail server 1.

 

enable alert logs (red exclamation point) - e-mail alerts for all

 

categories to e-mail server 1.

 

 

E-mail Server

Use the E-Mail Server 2 drop-down list to change the settings for e-

2

mailing logs to e-mail server 2 for all log categories.

 

Using the System Log drop-down list to disable all logs overrides your

 

e-mail server 2 settings.

 

enable normal logs (green check mark) - e-mail log messages for all

 

categories to e-mail server 2.

 

enable alert logs (red exclamation point) - e-mail alerts for all

 

categories to e-mail server 2.

 

 

Remote Server

For each remote server, use the Selection drop-down list to change the

1~4

log settings for all of the log categories.

 

disable all logs (red X) - do not send the remote server logs for any log

 

category.

 

enable normal logs (green check mark) - send the remote server log

 

messages and alerts for all log categories.

 

enable normal logs and debug logs (yellow check mark) - send the

 

remote server log messages, alerts, and debugging information for all

 

log categories.

 

 

#

This field is a sequential value, and it is not associated with a specific

 

address.

 

 

 

239

NWA3000-N Series User’s Guide