ZyXEL Communications NWA3000-N 15.6.4 Configuring SSH

Chapter 15 System

Click Configuration > System > SSH to open the following screen. Use this screen to configure your NWA3000-N series AP’s Secure Shell settings.

Note: It is recommended that you disable Telnet and FTP when you configure SSH for secure connections.

Figure 96 Configuration > System > SSH

The following table describes the labels in this screen.

Table 74 Configuration > System > SSH

LABEL	DESCRIPTION
Enable	Select the check box to allow or disallow the computer with the IP
	address that matches the IP address(es) in the Service Control table to
	access the NWA3000-N series AP CLI using this service.

Version 1	Select the check box to have the NWA3000-N series AP use both SSH
	version 1 and version 2 protocols. If you clear the check box, the
	NWA3000-N series AP uses only SSH version 2 protocol.

Server Port	You may change the server port number for a service if needed, however
	you must use the same port number in order to use that service for
	remote management.

Server	Select the certificate whose corresponding private key is to be used to
Certificate	identify the NWA3000-N series AP for SSH connections. You must have
	certificates already configured in the My Certificates screen.

Apply	Click Apply to save your changes back to the NWA3000-N series AP.

Reset	Click Reset to return the screen to its last-saved settings.