Chapter 5 WAN Setup
5.5.1.5 Default GatewayThe screen is not available when you select Bridging in the WAN Service Configuration screen.
Figure 47 WAN Configuration: Default Gateway: PPPoE, PPPoA, IPoE or IPoA
The following table describes the labels in this screen.
Table 27 WAN Configuration: Default Gateway: PPPoE, PPPoA, IPoE or IPoA
LABEL | DESCRIPTION | |
Selected Default | Select a WAN interface through which you want to forward the traffic. | |
Gateway | Select a WAN interface in the Available Routed WAN Interfaces | |
Interfaces | ||
box and use the | ||
| ||
Available Routed | Gateway Interfaces box to use that interface as the default | |
WAN Interfaces | gateway. | |
| To remove a WAN interface from the Selected Default Gateway | |
| Interfaces box, use the | |
| The interface on the top of the list gets the highest priority. | |
|
| |
Selected WAN | Select a WAN interface to use that interface as the system default | |
Interface | IPv6 gateway. | |
| This field is available only when you configure a WAN service with | |
| IPv6 enabled. You can only enable IPv6 for a WAN service that uses | |
| the PPPoE or IPoE encapsulation method over the ATM or PTM | |
| interface. | |
|
| |
Back | Click this button to return to the previous screen. | |
|
| |
Next | Click this button to continue. | |
|
|
118 |
| |
| ||
|
|
|