Chapter 19 Quality of Service (QoS)
19.6 The QoS Policer Setup Screen
Use this screen to configure QoS policers that allow you to limit the transmission rate of incoming traffic. Click Advanced > QoS > Policer Setup. The screen appears as shown.
Figure 163 QoS > Policer Setup
The following table describes the labels in this screen.
Table 106 QoS > Policer Setup
LABEL | DESCRIPTION |
Add | Click this button to create a new entry. |
|
|
No. | This is the index number of this entry. |
|
|
Active | Select the check box to enable the policer. |
|
|
Name | This field displays the descriptive name of this policer. |
|
|
Regulated | This field displays the name of a QoS classifier |
Classes |
|
|
|
Meter Type | This field displays the type of QoS metering algorithm used in this |
| policer. |
|
|
Parameter | This field displays the parameters configured for the metering |
| algorithm in the policer. |
|
|
Action | This field displays the actions taken on the matched traffic. |
|
|
Modify | Click the Edit icon to go to the screen where you can edit the policer. |
| Click the Remove icon to delete an existing policer. Note that |
| subsequent rules move up by one when you take this action. |
|
|
Apply | Click Apply to save your changes back to the |
|
|
| 319 |
|
|