Chapter 5 WAN Setup
The following table describes the fields in this screen.
Table 18 Layer 2 Interface
LABEL | DESCRIPTION |
Interface | Select an interface for which you want to configure here. |
| PTM: The |
| transmission over the DSL port. |
| ATM: The |
| transmission over the DSL port. |
| Ethernet: The |
| port. Select this if you have a DSL router or modem in your network |
| already. |
|
|
Current Mode | This displays whether the |
| Ethernet WAN port for Internet access. |
| When you set the DSL/WAN switch (on the back of the |
| 51c) to the DSL side, this displays PTM/ATM WAN. The WAN port |
| will be disabled automatically. |
| When you set the DSL/WAN switch to the WAN side, this displays |
| ETH WAN. The DSL port will be disabled automatically. This allows |
| the |
| router. To access the Internet, connect the WAN port to a broadband |
| modem or router. |
|
|
Interface | This is the name of the interface. |
|
|
Vpi | This is the Virtual Path Identifier (VPI). |
|
|
Vci | This is the Virtual Channel Identifier (VCI). |
|
|
Category | This is the ATM traffic class. |
|
|
Link Type | This is the DSL link type of the ATM |
|
|
Connection Mode | This displays the connection mode of the |
|
|
QoS | This displays whether QoS (Quality of Service) is enabled on the P- |
| |
|
|
Remove | Click the Remove button to delete this interface from the |
| 51c. A window displays asking you to confirm that you want to delete |
| the interface. |
| Note: You cannot remove the |
| service is associated with it. |
|
|
Add | Click this button to create a new |
5.4.1 Layer 2 Interface Configuration
Click the Add button in the Layer 2 Interface screen to open the following screen. Use this screen to create a new
102 |
| |
| ||
|
|
|