Chapter 15 Static Route
15.2.1 Static Route Edit
Click the Add button in the Static Route screen. Use this screen to configure the required information for a static route.
Figure 151 Static Route: Add
The following table describes the labels in this screen.
Table 95 Static Route: Add
LABEL | DESCRIPTION |
Destination IP | This parameter specifies the IP network address of the final destination. |
Address | Routing is always based on network number. If you need to specify a |
| route to a single host, use a subnet mask of 255.255.255.255 in the |
| subnet mask field to force the network number to be identical to the host |
| ID. |
|
|
IP Subnet | Enter the IP subnet mask here. |
Mask |
|
|
|
Use Interface | Select a WAN interface through which the traffic is sent. You must have |
| the WAN interface(s) already configured in the WAN screens. |
|
|
Use Gateway | Select this option and enter the IP address of the |
IP Address | gateway is a router or switch on the same segment as your |
| 51c's interface(s). The gateway helps forward packets to their |
| destinations. |
|
|
Back | Click Back to return to the previous screen without saving. |
|
|
Apply | Click Apply to save your changes back to the |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
| 295 |
|
|