Chapter 5 WAN Setup
Table 22 WAN Configuration: Service Type
LABEL | DESCRIPTION |
Rate Limit | Enter the maximum transmission rate in Kbps for traffic sent through the |
| WAN connection. Otherwise, leave this field blank to disable the rate |
| limit. |
| This field is not available for an ATM connection. |
|
|
Tag VLAN ID | Select this option to add the VLAN tag (specified below) to the outgoing |
for egress | traffic through this connection. |
packets | This field is available when the |
| |
|
|
Enter 802.1P | IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into |
Priority | a |
| Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through |
| this connection. The greater the number, the higher the priority level. |
| This field is available when the |
|
|
Enter 802.1Q | Type the VLAN ID number (from 1 to 4094) for traffic through this |
VLAN ID | connection. |
| This field is available when the PTM interface is in VLANMUX mode. |
|
|
Enable IPv6 for | Select this option to enable IPv6 for this WAN service so that the P- |
this service | |
| connection. |
| You can only enable IPv6 for a WAN service that uses the PPPoE or IPoE |
| encapsulation method over the ATM or PTM interface. |
|
|
Back | Click this button to return to the previous screen. |
|
|
Next | Click this button to continue. |
|
|
The screen differs by the encapsulation you selected in the previous screen. See Section 5.7 on page 125 for more information.
110 |
| |
| ||
|
|
|