Chapter 2 Tutorials
2Create interface groups in the Advanced Setup > Interface Group screen to map logical LAN groups to the PVCs you created. See Figure 2.3.2 on page 53.
3Configure IP addresses for devices in each interface group using the Network > LAN screen. See Figure 2.3.3 on page 57.
2.3.1Configuring PVCs
Follows the steps below to set up two PVCs on the
Table 3 Multiple PVC Settings
PVC | WAN SERVICE | |
0/33 | atm1 | PPPoE (pppoe_0_0_33) |
|
|
|
0/34 | atm2 | IPoE (ipoe_0_0_34) |
|
|
|
Note: Make sure you set the DSL/WAN switch (on the back of the
1Click Network > WAN > Layer 2 Interface.
2Select ATM from the Interface
44 |
| |
| ||
|
|
|