Chapter 1 Introducing the P-2812HNU-51c

Note: You must activate WPS in the P-2812HNU-51c and in another wireless device within two minutes of each other. See Section 7.11.4 on page 175 for more information.

1.5 The RESET Button

If you forget your password or cannot access the web configurator, you will need to use the RESET button at the back of the device to reload the factory-default configuration file. This means that you will lose all configurations that you had previously and the password will be reset to “1234”.

1.5.1 Using the Reset Button

1Make sure the POWER LED is on (not blinking).

2To set the device back to the factory default settings, press the RESET button for ten seconds or until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults have been restored and the device restarts.

 

29

P-2812HNU-51c User’s Guide