|
|
| OREGON® Cordless Tool System |
|
| OPERATING THE TRIMMER/EDGER | |
|
| ||
|
| TRIMMER/EDGER MODEL ST250 | |
|
|
| |
|
|
|
|
CHARGING THE BATTERY PACK
WARNING: FAILURE TO FOLLOW PROPER CHARGING PROCEDURES MAY CAUSE EXCESSIVE VOLTAGE, EXCESSIVE CURRENT FLOW, LOSS OF CONTROL DURING CHARGING, LEAKAGE OF HAZARDOUS CHEMICALS, HEAT GENERATION, BURSTING, OR FIRE.
With the charger cord connected to the charger and plugged into an electrical outlet, align the grooves in the battery with the rails on the charger and slide the battery pack onto the charger until fully seated (Fig. 9).
Fig. 9 |
Check the
INSERTING AND RELEASING
THE BATTERY PACK
Only use the OREGON® brand battery packs specified in these operating instructions.
Align the groove in the battery with the rails inside the battery port. Firmly insert the battery pack into the trimmer/edger’s battery port, pressing forward until it clicks as it locks into place (Fig. 10).
Fig. 10
To remove the battery pack, lift up on the battery release and remove the pack (Fig. 11).
Fig. 11
16 | AE 1212 - F/N 558937 |