IB_KH1282_E5554_UK_3 10.09.2007 16:20 Uhr Seite 6
Operating Elements
q Spray button
w Heating control lamp e Power cable with plug r Flexible cable restrainer t Back end
y Water tank
u Temperature controller i Sole of the iron
o Water fill opening a Water jet
s Steam controller/Self Clean d Steam blast button
f Measuring beaker
Preparation
Filling with water
You require water to be able to use the steam and spray functions. Water is not needed for dry ironing.
•Place the cooled down iron in an upright position on its back end t.
•Open the water fill opening o for the water tank
y.
•Using the measuring beaker f, pour in water to no further than the "Max" marking in the water tank y.
•Close the water fill opening o for the water tank
y.
Should the mains water at your locality be rated as hard, it is recommended that you mix mains water with some distilled water. Otherwise, the jets for the steam blast function could calcify (become blocked) prematurely.
To extend the optimal steam blast function, mix mains water with distilled water according to the table.
local water | Ratios - distilled |
hardness | water to mains water |
very soft / soft | 0 |
|
|
medium | 1: 1 |
|
|
hard | 2: 1 |
|
|
very hard | 3: 1 |
|
|
The water hardness level can be queried at your lo- cal water works.
Plugging in and ironing
Ironing tips
Sort the laundry in accord with the type of material. Always observe the ironing and care instructions given for the material. Start with the materials that require the lowest heat settings.
If you are not sure what material has been used in the garment, first of all carefully iron a small area
- 6 -