Honeywell SG-60 installation and operation guide Airport Systems

Airport Systems

6.If you have a Dual (Red/White) System: Verify normal red night mode operation.

(a)Verify that all Flashheads are OFF

(b)Verify that all Red Lights are ON and flashing properly, and the Red Light Controller does not indicate any alarms in the top-most Red Beacons.

(c)Verify that LED DS36 (EXT RED READY) is lit green (See Item 10, Figure 2-10, Page 2-25).

7.If you have a Dual (Red/White) System: Perform the following steps to check white night backup operation.

(a)Simulate a Top Red Beacon failure.

On a Honeywell 9LCA Series Control, this may be done with the B1 circuit breaker in the Control. Turn the B1 breaker off to activate the 9LCA Beacon Failure Alarm, or toggle the breaker momentarily to activate the 9LCA Flasher Bypass Alarm.

Other Redlight systems have different controls, and may require removing Red Beacon power at the input power circuit breakers.

(b)Verify that the DS36 (External Red Ready) LED is OFF.

(c)Verify that the DS32 (Night/Red) LED is ON

(d)Verify that the DS33 (Backup) LED is ON

(e)Verify that all the Red Lights are OFF

(f)Verify that all Flashheads are flashing in sync and in Night mode (lowest brightness, ~1/8 second duration bursts at 40 bursts per minute).

(g)Repair the simulated Red Beacon failure.

(h)Verify that DS36 (External Red Ready) LED is ON.

(i)Verify that the lighting system is still operating white strobes, and not red-lights.

(j)Set the MODE switch to DAY. Wait for the Flashheads to switch to DAY mode (about 6 seconds). Set the MODE switch back to NIGHT. Wait for the Flashheads to switch to OFF mode (about 6 seconds).

(k)Verify normal red night mode operation per Step 6 above.

(l)If you have more than one Red Beacon at the top level, repeat the simulated failure test for each Red Beacon.

SG-60 High Intensity Strobe System 2-32 Manual EPM-00000019 Rev A