Snom M9 quick start LI Installation, Side view

E

N snom m9 Quick Start Guide

G

LI Installation

SBefore first use, the handset battery should be charged

Hfully. This will take approximately 8 hours.

Preparation of handset

1.Lift off the battery cover.

2.Insert the battery pack with the electrodes in the top left corner. Replace the cover.

3.Connect the 5.9 V power supply of the charger to the wall outlet first, then to the charger, and place the handset in the charger.

1.	2.	3.
	snomRECHARGEABLE-ION
	LITHIUM
	BATTERY

Base station

	Call LED
	– flashes during firmware update
Registration LED	– lit when call in progress
– lit when the base	– blinks slowly when waiting for
	handset registrations
station is registered

Network LED

–flashes during boot, indicating that the base station has received an IP address

Power LED

– lit when on

snom m9 Quick Start Guide

1.When the handset is ready for use, connect one end of the network cable with the NET port on the back of the base station and the other end to a LAN port in your network (switch, router, etc.).

2.Connect the 5 V power converter to the wall outlet first, THEN to the base station.

Reset
button	RESET 5V DC	NET
	Power	Net port
	connector

3.The power indicator comes on and the base station begins to boot.

4.When the base station has booted up, the "Call" LED will start to blink, indicating that the base station is waiting for handset registration.

Handset overview

Side view

Belt clip

Volume adjust key+-

1. On idle screen press „+“ to show system status on- screen (IP address, MAC address/serial number)

2. Adjust volume

• of ringer when call is ringing

• of speaker when in call

Speakerphone key (on/off)

Headset jack connector 2.5 mm

Back view	Loudspeaker	Battery cover
	of
	speakerphone

E N G L I S H

14 15