troubleshooting
Problem | Cause | Possible Solution |
|
|
|
|
|
Pump does not prime | Prime/Spray valve is in Spray position | Turn Prime/Spray lever to Prime |
|
| Inlet screen is clogged or intake tube is not | Clean debris off inlet screen and make | |
| immersed | sure intake tube is at bottom of paint | |
|
| bucket |
|
| Inlet valve check ball is stuck | Tap firmly on the outside of the inlet valve | |
|
| with a small wrench, allowing pump to | |
|
| prime properly |
|
|
| Remove intake tube and place a pencil | |
|
| into the inlet section to dislodge the ball, | |
|
| allowing pump to prime properly. |
|
| Intake tube is loose | Tighten intake tube with | |
| screwdriver |
| |
|
|
|
|
Motor seems to be running | Reversible spray tip is worn | Replace spray tip |
|
properly but pressure drops when | Spray tip is clogged | Turn spray tip 180° and spray to clean | |
Suction tube and filter are loose or | Reinstall or replace suction tube and | ||
| |||
| damaged | filter as needed |
|
| Clean or replace | ||
| Material being sprayed is too thick | filter |
|
| Follow material manufacturer’s directions | ||
|
| ||
| Inlet valve is damaged or worn | and thin material as needed |
|
| Replace inlet valve |
| |
| Intake tube is loose |
| |
| Tighten intake tube |
| |
|
|
| |
|
|
|
|
Prime/spray lever is set to spray | Prime/spray lever is dirty or damaged | Contact Authorized Service Center |
|
but there is flow through the prime |
|
|
|
tube |
|
|
|
|
|
|
|
Internal sprayer parts are worn or | Contact Authorized Service Center |
| |
| damaged |
|
|
Nozzle tip guard leaks | Nozzle tip guard or spray tip were assembled | Reassemble according to nozzle tip guard | |
| improperly | and Spray tip assembly instructions |
|
|
|
| |
Spray tip is clogged | Turn spray tip 180° and spray to clean | ||
| Clean or replace | ||
| Spray tip is not fully seated into nozzle tip | filter |
|
| guard | Reassemble according to nozzle tip guard | |
|
| and Spray tip assembly instructions |
|
|
|
| |
Paint pattern is weak or uneven | Pressure is set too low | Turn variable pressure control to a higher | |
|
| setting |
|
| Clean or replace filters |
| |
| clogged |
|
|
| Intake tube is loose at inlet valve | Tighten tube fitting |
|
| Spray tip is worn | Replace spray tip |
|
| Material being sprayed is too thick | Follow material manufacturer’s directions | |
|
| and thin material as needed |
|
| Loss of pressure | See Cause/Possible solutions | for |
|
| Pressure setting is too low, and Motor | |
|
| seems to be running properly but | |
|
| pressure drops when | is |
|
| triggered |
|
14 — English