Fasteners
Typically, an 8d nail 6” (o.c.) is used to connect panels to top and
bottom plates at spline connections and for dimensional plating. Staples are permitted, provided they meet the following criteria: Minimum length = 1.5” 14 gauge
@6” o.c., 16 gauge
@4” o.c.
Field Fabrication
Field fabrication will be necessary on the site if you ordered stock panels. Even on factory fabricated panels, slight field modifications may be necessary to allow for panel growth or variations in the actual field dimensions. Modifications are not difficult. Common construction tools will suffice for most projects with the only additional recommended tool being a foam scoop/hot knife (available for purchase) for quick and easy recessing of the foam core.
When performing field modifications to panels, wait to make measurements and modifications until the previous panel has been placed into its final position. When cutting wall panels, make sure you have the correct panel, and that it is PROPERLY ORIENTED (horizontal electrical chases are at the bottom of the panel). Remember to take an extra 1/8” off the desired dimension. We recommend using a pencil to mark your lines on the panel skin, as chalk lines tend to blow off when the saw blade approaches.
12