Brother XL-6051, XL-6053, XL-6050, XL-6060, XL-6062 Optional Accessories, Using the Walking Foot

GUARNIZIONIUSO DE E APPLICAZIONIACCESORIOS Y APLICACIONES

USING ATTACHMENTS AND APPLICATIONS

A

1

2

1

B

C

OPTIONAL ACCESSORIES

Using the Walking Foot

Pattern	Stitch Length	Stitch Width
(Straight Stitch		0
(Center Needle Position))
(Zigzag Stitch)	1-4	Fixed 1.5
(Zigzag Stitch)		Fixed 3.5
(Zigzag Stitch)		Fixed 5

This foot is very useful for sewing materials such as vinyl cloth, synthetic leather, thin leather, etc. These materials are difficult to feed when sewing. The walking foot prevents such materials from crumpling, slipping or sticking between presser foot and material due to even feeding of upper and lower materials.

NOTE:

Use foot only for straight sewing (Center Needle Position) and zigzag stitching. Do not use other patterns.

1.Remove the power supply plug from the outlet.

2.Raise the needle and the presser foot.

3.Loosen the presser foot screw to remove the presser foot holder. (See fig. A)

4.Attach the forked section of the connecting lever to the needle clamp, install the walking foot to the presser bar. (See fig. B)

5.Lower the presser foot lever and then tighten the accessory presser bar holder fixing screw. (See fig. C)

1Forked part of operation lever

2 Presser bar holder

1Use a screwdriver

CAUTION

•Use the screwdriver to tighten the screw securely. If the screw is loose, the needle may strike the presser foot and cause injury.

•Be sure to turn the balance wheel toward the front of the machine to check that the needle does not strike the presser foot. If the needle strikes the presser foot, injury may result.

•Be careful not to touch the needle during this time, otherwise injury may result.

CAUTION

When sewing with the walking foot, sew at medium to low speeds.

71