Electrolux 15 manual Ice CubeThickness Adjustment, Interval As Required

Ice CubeThickness Adjustment

Interval - As Required

Ice thickness adjustments are made using the control panel as follows:

LIGHT,

UPDOWN BLACKOUT MODE

POWER ARROW DISPLAY ARROW & OTHER FUNCTIONS

ICE

Figure 27

1.To enter the thickness adjustment mode:

a.Touch and hold the UP ARROW button.

b.Touch and release the DOWN ARROW button three times, then release the UP ARROW button.

c.The display will switch to “0,” to confirm the thickness adjustment mode has been selected.

2.The factory setting is “0,” and the total range of adjustment is -5 to +5. Use the UP ARROW button to raise the setting and thicken the ice bridge, or the DOWN ARROW button to lower the setting to thin the ice bridge.

IMPORTANT

Ice thickness adjustment should only be made one increment at a time. Allow ice maker production to stabilize for 24 hours before rechecking ice thickness.

3.Touch and release the LIGHT button key to exit the ice thickness adjustment mode.

4.Remove all ice from the storage bin.

5.Ice cubes in any given batch will vary, so it is necessary to choose cubes from the sample area (Figure 28) for comparison when making adjustments. If further adjustments are desired, repeat steps 1 through 4.

IMPORTANT

It is extremely important that Clear Ice models are level. If not level, the ice mold will not fill evenly.