18Maintenance
2 Remove all ice from the storage bin.
3.Remove inside front cover. (See figure 31.)
FRONT
COVER
Figure 31
4.Remove Remove the overflow tube by lifting it while using a slight back and forth motion to loosen it from the drain hole. The water in the reservoir will flow down the drain. (See figure 32.)
OVERFLOW |
Figure 32 |
5Replace the overflow tube after all of the water has drained from the reservoir.
6Start the cleaning cycle as follows:
a Touch and hold the POWER button.
b Touch and release the LIGHT button three times, then release the POWER button.
c The display will show “CL” to confirm the beginning of the cleaning cycle.
7When water begins to flow over the evaporator (approximately 3 minutes), add one package of Electrolux Ice Machine Cleaner to the water reservoir.
8Reinstall inside front cover.
9When the
10Clean the storage bin. (See INTERIOR CLEANING). Sanatize the bin with a solution of 1 tablespoon of bleach and 1 gallon of warm water. Rinse thoroughly with clean water.
11To ensure the drain system is working properly, pour 1 gallon of cool, fresh water into the ice bin. The water should drain freely. If the unit is equipped with a drain pump, it should drain the ice bin.
When ice production resumes, the water fill valve will energize, fill the water reservoir, and shut- off after three minutes. The compressor begins to operate and water flows over the evaporator assembly (ice cube tray). Initially, the water flow may not be uniform, causing uneven sized cubes or water to spill into the ice storage bin. This is a normal situation that will correct itself within the first 24 hours of operation.
IMPORTANT
•Discard all ice produced in the first harvest.
•If power gets interrupted during the self- clean cycle, it will be necessary to repeat the complete cleaning cycle after power is restored.