Electrolux 15 manual Installation Dimensions, Installing the Drain

Installation 5

Installation Dimensions

	14 - 15/16”		24”
	(37.9)		(61)
34 - 1/8”
(86.7)
FULL
RETRACT	5”
HEIGHT
	(12.7)
		WATER	WATER
			VALVE
		DRAIN
WATER			21 - 3/4”
OUTLET
			(55.2)

Installing the Drain

CAUTION

PLEASE READ all instructions completely before attempting to install or operate the unit. All ice makers require a connection to the water supply and improper hook-up can result in substantial property damage! All water and drain connections MUST BE made by a licensed/qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm.

CAUTION

Plumbing installation must observe all state and local codes. All water and drain connections MUST BE made by a licensed/ qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm.

Model EI15IM55GS can be installed using a gravity drain or the Electrolux EIMP60, optional drain pump kit.

•Drain lines must have a 1 inch drop per 48 inches of run (1/4 inch per foot) and must not create traps.

•The floor drain must be large enough to accommodate drainage from all drains.

•Insulate the bin drain line to prevent condensation.

Figure 1

Follow these guidelines when installing drain lines to prevent water from flowing back into the ice maker storage bin and/or potentially flowing onto the floor causing water damage:

Gravity Drain

•Drain lines must have a 5/8 inch inside diameter.