Electrolux 15 manual Condenser Cleaning Every 3 Months, Self Cleaning Every 6 Months

Page 17

Maintenance 17

Condenser Cleaning — Every 3 Months

To maintain operational efficiency, clean the condenser every three months (depending on environmental conditions, more or less frequent cleaning may be necessary).

WARNING

Disconnect electric power to the ice maker before cleaning the condenser.

To remove and replace the grille for access to the condenser fins follow this procedure (see Figure 29):

1Remove the screws at each end of the grille.

2Remove the grille.

Figure 29

WARNING

DO NOT touch the condenser fins. The condenser fins are SHARP. The fins can also be easily damaged.

CAUTION

DO NOT use any type of cleaner on the condenser unit.

3Clean the condenser coil using a brush with a “combing” action, or a vacuum cleaner. Do not touch the condenser coil.

4Clean the grille, then position the grille to align the screw holes with the cabinet.

5Insert the grille screws and tighten. Do not over tighten.

Self Cleaning — Every 6 Months

To maintain operational efficiency, clean the unit every six months (depending on water conditions more or less frequent cleaning may be necessary). If the ice maker requires more frequent cleaning, consult a qualified plumber to test the water quality and recommend appropriate treatment.

WARNING

Wear rubber gloves and safety goggles and/ or face shield when handling Ice Machine Cleaner.

CAUTION

Use only Electrolux Ice Machine Cleaner (part number EIM30046).

It is a violation of Federal law to use this solution in a manner inconsistent with its labeling. Use of any other cleaner can ruin the finish of the evaporator and will void the warranty.

Read and understand all labels printed on the package before use.

Ice machine cleaner is used to remove lime scale and other mineral deposits. Refer to the following steps for mineral deposit removal.

CAUTION

Never use anything to force ice from the evaporator. Damage may result.

1Turn the ice maker off (allowing any ice to melt off of the evaporator) as follows:

a Touch and hold the POWER button.

b The display will switch from ICE to OFF to confirm that the ice maker is off. (See Figure 30.)

LIGHT,

UPDOWN BLACKOUT MODE

POWER ARROW DISPLAY ARROW & OTHER FUNCTIONS

OFF

Figure 30

Image 17 Contents
Use & Care Guide Please read and save this guide Finding InformationKeep a record for quick reference Questions?Table of Contents Important Safety Instructions SafetyInstalling the Drain Installation DimensionsConnecting a Drain Pump InstallationPreparing the Site Site PreparationWater Supply Connection Connecting the Water SupplyLeveling the unit LevelingReversing the Door some models Door ReversalDoor Closer Inserts Boss Adjusting the Door Door Adjustment Installing a Built-In Built-In Installation / Start-Up Initial Start-Up Normal Operating SoundsIce Dispenser Operation & Care OperationNormal Operation Interval As Required Ice CubeThickness AdjustmentSpecial Considerations MaintenanceMaintaining and Cleaning Your Icemaker Self Cleaning Every 6 Months Condenser Cleaning Every 3 MonthsOverflow Draining for non-use Inlet Screen Cleaning Every YearTroubleshooting Guide TroubleshootingBefore You call For Service Problem Possible Cause Remedy If Service is requiredConsumer Warranty InformationGuía de uso y cuidado Lea y conserve este manual Dónde obtener informaciónAnote estos datos para referencia futura ¿Preguntas?Índice Precauciones de seguridad Instrucciones importantes de seguridadDefiniciones Precauciones generalesDesagüe por gravedad Dimensiones de la instalaciónInstalación del desagüe Conexión de una bomba de desagüe InstalaciónPreparación del lugar de ubicación Preparación de la ubicaciónConexión del suministro de agua Conexión del suministro de aguaNivele la unidad NivelaciónInversión de la puerta algunos modelos Inversión de la puertaAbajo y el conector del agujero de la puerta Ajuste de la puerta Ajuste de la puertaInstalación empotrada Instalación empotrada y encendido inicialEncendido inicial Sonidos normales de funcionamientoGrosor de los cubitos de hielo FuncionamientoFuncionamiento normal Bomba de desagüe Ajuste del grosor de los cubitos de hieloIntervalo según se requiera Intervalo no se requiereMantenimiento y limpieza del fabricador de hielo MantenimientoFactores especiales a tener en cuenta Autolimpieza cada 6 meses Limpieza del condensador cada 3 mesesCubierta Delantera Drenaje de la unidad Servicio técnico, almacenamiento Vacaciones y transporteFiltro de limpieza una vez al año Antes de solicitar servicio técnico Localización y solución de averíasGuía de localización y solución de averías Sección MantenimientoLa sección Conexión del suministro de agua Si se requiere servicio técnicoEsta garantía no cubre lo siguiente Información sobre la garantíaSe enumeran a continuación Novembre Des questions? RenseignementsVeuillez lire et conserver ce guide Table des matières Mesures de sécurité Mesures de sécurité importantesDéfinitions Précautions généralesSystème de vidange par gravité Dimensions pour linstallationInstallation du tuyau de vidange Raccorder la pompe dévacuation InstallationPréparer lemplacement Préparation de lemplacementRaccorder l’alimentation en eau Raccordement de l’alimentation en eauMettre l’appareil à niveau Mise à niveauInverser la porte certains modèles Inversion de la porteAlignées avec les trous de la charnière et de la Ajuster la porte Ajustement de la porteEncastrer lappareil Installation encastrée / Mise en marcheMise en marche initiale Bruits d’un fonctionnement normalFonctionnement normal FonctionnementFonctionnement et entretien de la machine à glaçons Épaisseur des glaçonsPompe dévacuation Réglage de lépaisseur des glaçonsIntervalle de réglage Au besoin Intervalle de réglage Non nécessaireEntretenir et nettoyer votre machine à glaçons EntretienSituations particulières Autonettoyage Tous les six mois Nettoyage du condenseur Tous les trois moisPanneau Avant Vidange dun appareil inutilisé Nettoyage de la grille d’entrée Chaque année20 Dépannage Avant de faire appel au service après-venteGuide de dépannage Consultez la section Mise à niveau de l’appareilRaccordement de l’alimentation en eau Si vous devez faire appel à notre service après-venteDépannage Cette garantie ne couvre pas ce qui suit GarantieDe ce qui figure dans la liste suivante