Appendix: Greeter Module
1.Navigate to Playback After Delay Of >XX< Seconds where “xx” represents the current number of seconds.
2.Change the number of seconds to a new value. The range is 0 to 15 seconds.
Change Playback Mode
Perform the following procedure to change the greeter playback mode.
1.Navigate to Playback Mode.
2.Change the value of the playback setting. Your choices are:
∙
∙PLAY
Set Greeter Playback through Headsets
You have the choice of allowing the greeting to be played through the headsets in addition to being played to the customer at the order point.
Perform the following procedure to enable or disable playback through headsets:
1.Navigate to Playback To The Headsets?.
2.Change the value of the playback setting. Your choices are:
∙YES - The greeting will play on the headsets as well as the order point.
∙NO - The greeting will only be heard at the order point (and the monitor if selected below).
:GREETER MESSAGE PROPERTIES:
Playback Through The Monitor?<YES>
Tone To Headsets During Playback?<NO >
Restaurant Closed Playback Message<OFF>
Set Playback through Monitor
You have the choice of allowing the greeting to be played through the monitoring speaker in addition to being played to the customer at the order point.
Perform the following procedure to enable or disable playback through the monitor:
1.Navigate to Playback Through The Monitor.
2.Change the value of the playback setting. Your choices are:
∙YES - The greeting will play on the grill monitor speaker as well as the order point.
∙NO - The greeting will only be heard at the order point.
Turn on Tone to Headsets During Greeter Playback
If the greeting is not playing over the headsets, a continuous tone can be played while the customer is hearing the greeting. This permits the order taker to know when the greeting is playing and when it has stopped.
To enable or disable the tone during greeter playback:
1.Navigate to Tone To Headsets During Playback.
3M™ | November 6 2014 – Revision 2.1 |
Operating Instructions | Page 67 of 77 |