3M XT-1, G5 operating instructions November 6 2014 Revision

Operation

∙On the opposite side of the Headset Carrier, ensure that the Control Pod Locking Mechanism is in the unlocked position by sliding it all the way to the left. A small flat head screwdriver or other similar tool can be used to slide the locking mechanism if needed. See Figure 1 below.

∙Align Charging Contact Block on Control Pod into the Charging Contact Block Receptacle of the Headset Carrier. Once the Charging Contact Block is set into in the Receptacle it will act as hinge or pivot point. See Figure 2

∙Gently press the two halves together until they securely snap into place at the top. You may need to apply a slight downward pressure to align the connections appropriately. When the Control pod is connected to Carrier you will hear a slight click sound. See Figure 3

∙Slide locking mechanism on opposite side of carrier to the locked position. See Figure 1.

∙Insert battery into the now assembled headset. See Figure 4.

∙LED indicator lights on the Headset should start blinking (refer to component Identification and Description section below). The headset is now ready for registrations to a base station.

Figure 1

November 6 2014 – Revision 2.1	3M™ Drive-Thru Systems Model G5 and Model XT-1
Page 32 of 77	Operating Instructions