3M G5, XT-1 operating instructions Charging Status Indicator

Page 53

Maintenance

Low Battery Message

When the battery voltage is too low, the headset sounds a “change battery now” message at fifteen-second intervals to alert the operator to install a fully charged battery. The “change battery now” message continue s for two minutes after which the headset turns off automatically to prevent damage to the batteries.

Charging Batteries

To charge a battery, insert the battery in one of the charging slots.

∙The indicator lights RED to indicate the battery is charging.

∙The indicator lights GREEN to indicate the battery is charged.

Note:

Discharged batteries require 3 ½ hours to charge.

Note:

When the GREEN indicator lights, the battery is approximately 80% charged. An additional 1/2 hour of charging is required to achieve maximum charge.

Charging

Status

Indicator

Disposing of Batteries

To help protect the environment and conform to regulations, 3M™ Wireless Communication System Model XT-1 rechargeable batteries must be returned to 3M at the end of their useful life. Contact your 3M representative for additional instructions.

Making Sure Batteries are Ready for Use

Follow these tips to make sure batteries are always ready for use:

∙Have an extra battery for each headset. This helps ensure that a fully charged battery is always available.

∙Recharge a low battery as soon as it is removed from the headset. When a battery is low, repeat messages are heard in the headset for 2 minutes, and then the headset shuts off.

∙Keep the battery and charger contacts clean. Use a cotton swab and approved cleaner in accordance with manufacturer’s instructions to clean the contact surfaces.

3M™ Drive-Thru Systems Model G5 and Model XT-1

November 6 2014 – Revision 2.1

Operating Instructions

Page 53 of 77

Page 52 Page 54
Image 53
Page 52 Page 54
Contents Operating Instructions 3M Commercial Solutions Division Table of Contents Assembling a 3M Drive Thru Headset G5 Maintenance Index Alert Message External Trigger InputsOverview Safety InformationImportant Notes and Notes Other ConventionsImportant Note FCC and Industry Canada InformationFCC and IC Identifiers FCC NoteRecycling / Disposal Notice to European Union customers Navigating the Base Station Display ConfigurationEnter Configuration Mode Buttons Interpreting Display InformationConfiguring with a Computer Logging into the Base Station with a PC ∙ Cycle the power to the base stationInbound Microphone Volume Change Basic Volume SettingsOutbound Talk Volume Vehicle Alert VolumeInbound Listen Change the Monitor VolumeOutbound Talk Vehicle PresentVehicle Approach Change the Night VolumeMessages Greeter MessagesRemove Headsets Registering HeadsetsAdd Headsets Resetting Inactive Days List All HeadsetsChange Noise Reduction Level Checking Headset Software RevisionAcoustic Echo Canceller Change Global SettingsDrive Thru Audio Duplex Mode Set System Date and TimeStore is Now Closed Prompt Channel Heard by Order TakerNumber of Base Stations at this Site Customer Order Point Prompt Language Pull Ahead PromptDetector Type Order Takers and Page Messages in Cross Lane ModeOrder Point Talk with No Vehicle Important Notes Kitchen Noise ReductionXT-1 Basestation Software Update Kit XT-1 Order Taking Modes SetupHaptics Vibration Alerts on Headsets Blue LED Alerts on HeadsetsHoliday/Exception Schedule Change Site SchedulingRegular Site Schedule Change Self Monitoring Change Site InformationChange Passcodes User PasscodesInstaller Setup Two Base Station SetupLoad Installation Settings Save Installation SettingsReboot System Factory Setup Restore Factory DefaultsActivate the Backup Intercom Create and Load TemplatesPage 3M Drive Thru Headset G5 OperationNovember 6 2014 Revision Operation 3M Drive-Thru Systems Model G5 and Model XT-1 ∙ T1 and T2 Talkbuttons Connect you to the order point Component Identification and DescriptionG5 Battery Indicator Light Modes Indicator Light ModesG5 Headset Indicator Light Modes Fitting the Headset Replace the Battery Out of Range XT-1 HeadsetsCleaning Component Identification and Description Headset Replace the Battery Out of Range Change Order Taking Mode Base Station SetupNavigating in the Base Station in Run Mode Talk Manual Latching, Push to Talk, Automatic Explanation of Order Taking ModesListen Auto, Manual, and Always On Split Lane Which Order Taking Mode to SelectChange Lane Mode Cross Lane Change Volume ModeG5 Headset MaintenanceReplacing the Carrier Disassembling the Carrier from the PodRefitting the headset with the new Carrier G5 Headset ChargerReplacing the Ear and Headband Pads LocationLow Battery Message Cleaning the Contacts in the Headset Charger wellsG5 Batteries Care, Handling and StorageImportant Information about Rechargeable Batteries Disposing of BatteriesMaking Sure Batteries are Ready for Use Cleaning the Contacts XT-1 Battery ChargerXT-1 Headset XT-1 BatteriesCharging Status Indicator Important Information about Rechargeable Batteries Headset Indicator Lights TroubleshootingG5 Headset Indicator Light Modes Problem Possible Cause Solution General TroubleshootingPress the other button into the correct XT-1 Battery and Battery Charger Battery and Battery Charger TroubleshootingAppendix Declaration of Conformity Physical Appendix Base Station SpecificationsElectrical FunctionalAppendix G5 Charger Specifications Appendix Greeter Module Greeter SetupEnter the Greeter Configuration Menu Record Message Message ActivationChoose Headsets Messages Playback To NameBreakfast Service=StartGreeter Message Properties Change Playback Delay TimeMessage Daypart Definitions Set Greeter Playback through Headsets Change Playback ModeTurn on Tone to Headsets During Greeter Playback Set Playback through MonitorGreeter Revision Turn on Restaurant Closed Playback MessageTurn on External Detector Playback Message Alert & Reminder Message Properties Alert & Reminder Message PropertiesDual Lane Systems Lane Message NamesTandem Pull Ahead Playback Message Start Time Greeter Setup System DefaultsDelay Count Alert & Reminder Properties Greeter Setup Customer SettingsGreeter Setup Example Settings 66, 67, 68, 69 IndexTalk 3M, Thinsulate, Tufcote and ScotchBrite are trademarks of 3M
Related manuals
Manual 8 pages 46.54 Kb

G5, XT-1 specifications

The 3M G5 XT-1 is a cutting-edge respirator designed for professionals who require advanced protection in various hazardous environments. With its innovative features, this respirator stands out in the market, providing users with an optimal balance of safety, comfort, and performance.

One of the main features of the 3M G5 XT-1 is its advanced filtration technology. Equipped with highly efficient particulate filters, these respirators are designed to capture airborne particles, including dust, smoke, and other harmful contaminants. This effectiveness is further enhanced by the use of activated carbon in certain filter models, which provides an additional layer of protection against gases and odors. The filters are easy to replace, ensuring that users can maintain their equipment without hassle.

Another key characteristic of the G5 XT-1 is its ergonomic design. The respirator is engineered to provide an excellent fit, reducing the likelihood of leakage and ensuring that users receive optimal protection. The adjustable straps and customizable nose bridge allow for a snug fit on various face shapes and sizes, enhancing comfort during prolonged use. This is particularly important for professionals in fields such as construction, healthcare, and manufacturing, who may wear respirators for extended periods.

The G5 XT-1 also features a lightweight construction, which contributes to user comfort. This lightweight design, combined with features such as breathing valves, enhances airflow, reducing breathing resistance. This means that users can perform their tasks more efficiently while experiencing less fatigue.

Another notable technology integrated into the G5 XT-1 is its dual mode of operation. Users can switch between disposable and reusable options, which is particularly advantageous for those who want to balance cost and sustainability. The reusable aspect of the respirator also encourages environmental friendliness by reducing waste.

In conclusion, the 3M G5 XT-1 respirator is a comprehensive solution for those seeking high-performance respiratory protection. With its advanced filtration technologies, user-centric design, and flexible operation modes, the G5 XT-1 meets the diverse needs of professionals working in challenging environments. Its focus on safety, comfort, and adaptability secures its place as a top choice for respiratory protection in various industries.
Top Page Image Contents