3M G5, XT-1 operating instructions FCC Note, FCC and IC Identifiers

Page 9

Overview

The XT-1 Base Station complies with FCC RF radiation exposure limits. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This includes any external antenna. For any external antenna that is used with the XT-1 Base Station, the minimum length of RF cable required is 75 feet.

The use of accessories not approved by 3M Company, including but not limited to batteries, antennas, wall adapters, chargers, ear pads and foam tips and convertible covers, may cause your headset to malfunction or in the case of unapproved electrical accessories may cause the devise to exceed RF energy exposure guidelines.

FCC Note:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Canada Note: CAN ICES-3 A/NMB-3 A

This device complies with part 15 of the FCC Rules and with Industry Canada license-exempt standard RSS-210 as of the date printed. Operation is subject to the following two conditions: (1) this device may cause interference, and

(2)this device must accept any interference, including interference that may cause undesired operation of the device.

Cet appareil est conforme avec la norme RSS-210 d'Industrie Canada exempte de licence à compter de la date imprimée. Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil peut causer des interférences, et

(2)cet appareil doit accepter toute interférence,y compris celles pouvant provoquer un fonctionnement indésirable de l'appareil.

FCC and IC Identifiers:

XT-1 Headset:

FCC ID: DGFBCSDXT1H

IC: 458A-BCSDXT1H

XT-1 Base Station:

FCCID: DGFBCSDXT1B

IC: 458A-BCSDXT1B

3M™ Drive Thru Headset G5:

FCCID: DGFBCSDG5H1

IC: 458A-BCSDG5H1

3M™ Drive-Thru Systems Model G5 and Model XT-1

November 6 2014 – Revision 2.1

Operating Instructions

Page 9 of 77

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Operating Instructions 3M Commercial Solutions Division Table of Contents Assembling a 3M Drive Thru Headset G5 Maintenance Index Alert Message External Trigger InputsOverview Safety InformationImportant Notes and Notes Other ConventionsImportant Note FCC and Industry Canada InformationFCC and IC Identifiers FCC NoteRecycling / Disposal Notice to European Union customers Configuration Enter Configuration ModeNavigating the Base Station Display Buttons Interpreting Display InformationConfiguring with a Computer Logging into the Base Station with a PC ∙ Cycle the power to the base stationInbound Microphone Volume Change Basic Volume SettingsOutbound Talk Volume Vehicle Alert VolumeInbound Listen Change the Monitor VolumeOutbound Talk Vehicle PresentVehicle Approach Change the Night VolumeMessages Greeter MessagesRegistering Headsets Add HeadsetsRemove Headsets Resetting Inactive Days List All HeadsetsChange Noise Reduction Level Checking Headset Software RevisionAcoustic Echo Canceller Change Global SettingsDrive Thru Audio Duplex Mode Set System Date and TimeChannel Heard by Order Taker Number of Base Stations at this SiteStore is Now Closed Prompt Customer Order Point Prompt Language Pull Ahead PromptOrder Takers and Page Messages in Cross Lane Mode Order Point Talk with No VehicleDetector Type Important Notes Kitchen Noise ReductionXT-1 Basestation Software Update Kit XT-1 Order Taking Modes SetupHaptics Vibration Alerts on Headsets Blue LED Alerts on HeadsetsChange Site Scheduling Regular Site ScheduleHoliday/Exception Schedule Change Self Monitoring Change Site InformationChange Passcodes User PasscodesInstaller Setup Two Base Station SetupLoad Installation Settings Save Installation SettingsReboot System Factory Setup Restore Factory DefaultsActivate the Backup Intercom Create and Load TemplatesPage 3M Drive Thru Headset G5 OperationNovember 6 2014 Revision Operation 3M Drive-Thru Systems Model G5 and Model XT-1 ∙ T1 and T2 Talkbuttons Connect you to the order point Component Identification and DescriptionG5 Battery Indicator Light Modes Indicator Light ModesG5 Headset Indicator Light Modes Fitting the Headset Replace the Battery XT-1 Headsets CleaningOut of Range Component Identification and Description Headset Replace the Battery Out of Range Base Station Setup Navigating in the Base Station in Run ModeChange Order Taking Mode Explanation of Order Taking Modes Listen Auto, Manual, and Always OnTalk Manual Latching, Push to Talk, Automatic Which Order Taking Mode to Select Change Lane ModeSplit Lane Cross Lane Change Volume ModeG5 Headset MaintenanceReplacing the Carrier Disassembling the Carrier from the PodRefitting the headset with the new Carrier G5 Headset ChargerReplacing the Ear and Headband Pads LocationLow Battery Message Cleaning the Contacts in the Headset Charger wellsG5 Batteries Care, Handling and StorageDisposing of Batteries Making Sure Batteries are Ready for UseImportant Information about Rechargeable Batteries Cleaning the Contacts XT-1 Battery ChargerXT-1 Headset XT-1 BatteriesCharging Status Indicator Important Information about Rechargeable Batteries Headset Indicator Lights TroubleshootingG5 Headset Indicator Light Modes Problem Possible Cause Solution General TroubleshootingPress the other button into the correct XT-1 Battery and Battery Charger Battery and Battery Charger TroubleshootingAppendix Declaration of Conformity Physical Appendix Base Station SpecificationsElectrical FunctionalAppendix G5 Charger Specifications Greeter Setup Enter the Greeter Configuration MenuAppendix Greeter Module Record Message Message ActivationChoose Headsets Messages Playback To NameBreakfast Service=StartChange Playback Delay Time Message Daypart DefinitionsGreeter Message Properties Set Greeter Playback through Headsets Change Playback ModeTurn on Tone to Headsets During Greeter Playback Set Playback through MonitorTurn on Restaurant Closed Playback Message Turn on External Detector Playback MessageGreeter Revision Alert & Reminder Message Properties Alert & Reminder Message PropertiesDual Lane Systems Lane Message NamesTandem Pull Ahead Playback Message Greeter Setup System Defaults Delay CountStart Time Alert & Reminder Properties Greeter Setup Customer SettingsGreeter Setup Example Settings 66, 67, 68, 69 IndexTalk 3M, Thinsulate, Tufcote and ScotchBrite are trademarks of 3M
Related manuals
Manual 8 pages 46.54 Kb
Top Page Image Contents