Shindaiwa 326T, 82085 manual Warranty Statement, Shindaiwa Corporation

Page 29

Warranty Statement

Shindaiwa Corporation

EPA PHASE 2 / CALIFORNIA TIER III EMISSION

CONTROL WARRANTY STATEMENT - WARRANTY RIGHTS AND OBLIGATIONS

English

The Environmental Protection Agency (EPA) and the California Air Resources Board (C.A.R.B.) and Shindaiwa Inc. are pleased to explain the emission control system warranty on your EPA Phase 2

/C.A.R.B. Tier III model year 2007 and later small off road engine (SORE). New small off road engines must be designed, built and equipped to meet stringent EPA and C.A.R.B. anti-smog standards. Shindaiwa Inc. warrants the emission control system on your small off road engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your small off road engine.

Your emission control system may include parts such as: carburetor/ fuel injected system, ignition system, catalytic converter, fuel tank, fuel lines, fuel caps, valves, canisters, filters vapor hoses, clamps connectors, and other associated components. For certain hand- held products with engines less than or equal to 80cc displacement, the fuel tank is subject to the C.A.R.B. evaporative emission control warranty requirements of this section. Contact Shindaiwa Inc. for the models covered under the C.A.R.B. evaporative emission regulations.

Where a warrantable condition exists, Shindaiwa Inc. or its authorized service representative will repair your small off road engine at no cost to you including diagnosis, parts and labor.

MANUFACTURER’S WARRANTY COVERAGE:

The 2007 and later small off road engines are warranted for two years for certain emission related parts. If any emission-related part on your engine is defective, the part will be repaired or replaced by Shindaiwa Inc. or its authorized service representative.

OWNER’S WARRANTY RESPONSIBILITIES:

■■As the small off road engine owner, you are responsible for the performance of the required maintenance listed in your Operator’s Manual. Shindaiwa Inc. recommends that you retain all receipts covering maintenance on your small off road engine, but Shindaiwa Inc. cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

■■As the small off road engine owner, you should however be aware that Shindaiwa Inc. may deny you warranty coverage if your small off road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your small off road engine to Shindaiwa Inc.’s authorized service center as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you can contact Shindaiwa Inc. at 800-521-7733 or www.shindaiwa.com

EPA PHASE 2 / CALIFORNIA TIER III EMISSIONS DEFECT WARRANTY EXPLANATION

This is additional detailed information about the EPA PHASE 2/ CALIFORNIA TIER III EMISSIONS DEFECT WARRANTY for your small off road engine.

WHAT DOES THIS WARRANTY COVER?

Shindaiwa Inc. warrants that your unit was designed, built and equipped to conform with applicable EPA and California emissions standards and that your unit is free from defects in material and workmanship that would cause it to fail to conform with applicable requirements within two (2) years. The warranty period begins on the date the product is delivered to a retail purchaser. This is your emission control system DEFECTS WARRANTY.

HOW WILL A COVERED PART BE CORRECTED?

If there is a defect in a part covered by this warranty, Shindaiwa Inc.’s authorized service dealer will correct the defect.

You will not have to pay anything to have the part adjusted, repaired or replaced. This includes any labor and diagnosis for warranted repairs performed by the dealer. In addition, engine parts not expressly covered under this warranty but whose failure is a result of a failure of a covered part will be warranted.

Emissions System repairs covered under this warranty should be completed in a reasonable time, not to exceed 30 days.

IMPORTANT

If the diagnosis reveals no defect, the emission defect warranty does not apply.

WHAT PARTS ARE COVERED BY THE EPA PHASE 2/CALIFORNIA TIER III 2007 & LATER SMALL OFF ROAD ENGINE EMISSIONS DEFECT WARRANTY?

■■Any emission related part not scheduled for, “required

maintenance” (See Operator’s Manual, “SERVICE MAINTENANCE SCHEDULE”) will be repaired or replaced within the warranty period. The repaired or replaced part will be warranted for the remaining Emissions Defect warranty period.

■■Any emission related part scheduled for replacement during “required maintenance” (See Operator’s Manual, “SERVICE MAINTENANCE SCHEDULE”) is warranted for the period of time prior to the first scheduled replacement point for that part. Any such part repaired or replaced under warranty shall be warranted for the remainder of the period prior to the first scheduled replacement point for that part.

■■Any Shindaiwa Inc. approved replacement part may be used in the performance of any warranty maintenance or repairs on emission- related parts, and must be provided without charge if the part is still under warranty.

■■Any replacement part that is equivalent in performance and durability may be used in non-warranty maintenance or repairs, and shall not reduce the warranty obligations of Shindaiwa Inc.

■■The owner is responsible for the performance of the required maintenance described in the operator’s manual.

SPECIFIC EMISSION RELATED WARRANTED PARTS:

Choke

Carburetor (complete assembly or replaceable components) Fuel Injection Assembly or replaceable components

Air Filter

Electronic Ignition System

Spark Plug

Catalytic Converter / Muffler Assembly

Fuel Tank (CARB only)

WHAT IS NOT COVERED BY THE EPA PHASE 2/CALIFORNIA TIER III 2007 & LATER SMALL OFF ROAD ENGINE EMISSIONS DEFECT WARRANTY?

■■Any failure caused by abuse, neglect, improper maintenance.

■■Any failure caused by unapproved modifications, use of unapproved add-on parts/modified parts or unapproved accessories.

29

Image 29
Contents FR1 Shindaiwa OWNER’S/OPERATOR’S ManualOther safety precautions Kickback safety precautions for chain saw usersDo not operate a chain saw when you are fatigued Rules for Safe OperationRules for Safe Operation International Symbols ContentsTechnical Data Emission Control ContentsEmission Data DescriptionSpark Plug Rear Top Handle 326TNomenclature of Parts For Canadian Models LabelsFor California models Guide BAR Chain Replacement BAR and Chain Type LinksKick guard to bar instructions Guide bar and saw chain-install/ removeADJUSTMENT, Chain Tension Fuel and Lubricant Fuel statementMixing Instructions Fuel Mix ChartChain Lubricant After useOperation Starting Cold EngineStopping Starting Warm EngineRunning Cutting Instructions GeneralSelect path of retreat Felling a TreeFelling big trees LimbingDON’T cut with saw overhead Kickback is DangerousBucking KickbackMaintenance and Care Maintenance IntervalsMaintenance Procedure Notes Skill LevelsAutomatic Oiler AIR FilterOIL Strainer Fuel StrainerSprocket Cooling System CleaningSpark Plug Muffler SideCylinder Exhaust Port Exhaust Port Cleaning LevelMuffler Spark Arrester Before Making Adjustments Carbuerator AdjustmentLOW Altitude Adjustment High Altitude AdjustmentChain and Guide Bar Combinations Setting the SAW ChainFollowing combinations may be used on 326T 91VG-45Storage After Use Chain Type and Sprocket PitchFuel is reaching cylinder High TroubleshootingEnglish Testing the Brake InstallationOperation Correct Use of Chain BrakeShindaiwa Corporation Warranty StatementPage ¡ADVERTENCIA 326T MotosierraAdvertencia Otras Precauciones De SeguridadAdvertencia Peligro Símbolos internacionales Datos Técnicos Control de emisiones Datos EmisionesDescripción Durabilidad DE LAS Emisiones DEL ProductoNomenclatura de las Partes Descripción Etiqueta Para modelos canadiensesNo Número de parte Etiqueta Para modelos de CaliforniaImportante Barra de guíay cadena de sierra instalar/quitarAdvertencia Peligro Nota Ajuste de la tensión la cadenaPeligro Combustible y lubricante Declaración de combustibleLubricante de la cadena Instrucciones de mezclaTabla de mezcla Después de usar¡IMPORTANTE Arranque del motor en fríoParada Arranque con el motor calienteFuncionamiento Instruccións para el Corte GeneralidadesContragolpa AvisoComo Derribar UN Árbol Advertencia Peligro EL Contragolpe ES Peligroso ContragolpeIntervalos de mantenimiento Nivel de habilidadMantenimiento y cuidado Notas DE Procedimientos DE MantenimientoAceitador automático Filtro de aireColador de aceite Colador de combustibleBujía Rueda dentadaLimpieza de los sistemas de engriamiento Lado Del SilenciadorLimpia del orificio de escape Nivel Apagachispas del silenciadorOrificio de escape del cilindro Antes DE Hacer LOS Ajustes Adjuste del carburadorAjuste DE Baja Altitud No Quite LOS Casquillos DEL LimitadorLime los cortadores como se muestra abajo Ajuste de la Cadena de la SierraCombinaciones de la Cadena y Guía de la Barra Abajo se muestran los cortadores afilados correctamente Tipo DE Cadena Y Paso DE LA Rueda DentadaIdentificación de Problemas Advertenciapeligro TablaOPERACIóN InstalaciónPrueba DEL Freno Uso Correcto del Freno de la CadenaDeclaratión de la Garantía NotAs AVERTISSEMENT ! pendant l’utilisation de l’appareil Manuel D’UTILISATION ShindaiwaArrêter le moteur avant de poser la chaîne Autres précautions à prendreRègles de sécurité d’utilisation Avertissement Danger Symboles internationaux Données techniques Contenu Contrôle d’ÉmissionDonnées d’Émission Durabilité DU Contrôle DES ÉmissionsNomencalture des pièces Pour les modèles canadiens EtiquettesPour les modèles Californie Avertissement danger Guide et lachaîne remplacement et installationInstructions pour kick guard et guide Réglage de la tension de la chaîne de scie Carburant et lubrificant Spécifications pour le carburantAvertissement Lubrificant de chaîne Instructions de mélangeTableau de mélange de carburant Après utilisationRemarque Démarrage d’un moteur froid Avertissement dangerFonctionnement Arrêt Démarrage d’un moteur chaudUtilisation Instructions pour la coupe GénéralitésÉbranchage Abattage D’UN ArbreTronçonnage LE Rebond EST DangereuxRebond Attaque incorrecte Se conformer aux mesures de sécurité du début de ce manuelNiveaux DE Difficulté Maintenance et entretienIntervalles D’ENTRETIEN Remarques Concernant L’ENTRETIENGraisseur automatique Filtre à airFiltre à huile Tamis de carburantBougie PignonCôté Du Silencieux Côté De DémarreurNettoyage de l’échappement de cylindre Niveau Silencieux et pare-étincellesLumière d’échappement du cylindre Rodage du moteur Réglage du carburateurRéglage pour Basse altitude Réglage pour haute altitudeCombinaisons de chaînes et guides Aiguisage de la chaîneRemisage Type DE Chaîne ET PAS DE PignonPas démarre Démarre DépannageAvertissement Danger TableauUsage correct du frein de chaîne FonctionnementTest DU Frein Déclaration de garantie