3D Connexion GNS 530(A) manual Utility Page Checklists, Creating a checklist

SECTION 10

AUX PAGES

If a ‘WARN’ annunciation appears at the bottom left corner, GPS satellite coverage may be sufficient, but the GNS 530 has detected a position error which exceeds protection limits. In this condition, all GPS navigation data on the GNS 530 is disabled. Use an alternate navigation source.

•Software Versions - Provides software version information for the operating software within the GPS receiver, COM transceiver, and main processor board.

•Database Versions - Displays the current Jeppesen database type and expiration date, along with the version and type of built-in land database.

•Terrain Database Versions - Displays the current version and area of coverage of each terrain and obstacle database. If a database is found to be missing and/or deficient, the TAWS system fails the self-test and issues a failure message.

Utility Page: Checklists

Creating a checklist:

1)Select ‘Checklist’ from the Utility Page using the steps described at the beginning of this section (10.3). Press the ENT Key to display a list of checklists.

2)Press the MENU Key to display the Checklist Page Menu (Figure 10-18). Turn the large right knob to select ‘Create New Checklist?’ and press the ENT Key.

Figure 10-18 Checklist Page Menu

3)Use the small and large right knobs to enter the name of a checklist. Press the ENT Key when finished. (Up to nine different checklists can be created and stored in the GNS 530.)

4)Use the small and large right knobs to enter each checklist item, followed each time by the ENT Key. Each checklist may contain up to 30 line items of as much as 16 characters long.

10-12 GNS 530(A) Pilot’s Guide and Reference 190-00181-00 Rev. E