Aastra Telecom 57I C53I manual Configuring Vlan optional, Select Operation-Reset and click

IP Phone Administrator Guide

Advanced Network Settings

PhonesIPthe		.
		Aastra Web UI
	Step	Action
	1	Click on Advanced Settings->Network->Type of Service,DSCP.
Configuring
	2	Choose a Protocol (SIP, RTP, and/or RTCP), and enter a value from 0 to 63.
		Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled, you will need to map
		the applicable priority to the Protocol setting as shown in the table “DSCP Range/VLAN Priority” on
		page 4-36 For more information, see the section “Configuring VLAN (optional)” on page 4-36.
	3	Click	to save your settings.
		Note: The session prompts you to restart the IP phone to apply the configuration settings.
	4	Select Operation->Reset and click		..

Configuring VLAN (optional)

Use the following procedures to configure VLAN on the IP phone.

Note: VLAN is disabled by default. When you enable VLAN, the IP phones use the default settings for each VLAN parameter. You can change the default settings if required using the following procedure.

4-36 41-001160-00, Rev 01 Release 2.0