Aastra Telecom 57I C53I manual Configuring Automatic Update

Firmware Upgrade

Upgrading the Firmware

Configuring Automatic Update

Use the following procedures to configure automatic update of the IP phone firmware, configuration files, or both.

Notes:

1. If a user is accessing the Aastra Web UI, they are not informed of an auto-reboot.

2.Any changes made using the Aastra Web UI or the IP phone UI are not overwritten by an auto-resync update. Auto-resync affects the configuration files only. However, the settings in the Aastra Web UI take precedence over the IP phone UI and the configuration files.

3.If the IP phone is in use (not idle) at the time of the resync check, the reboot occurs when the phone becomes idle.

4.The resync time is based on the local time of the IP phone.

5.Auto-Resync adds up to 15 minutes random time to the configured time. For example, if the auto resync time parameter is set to 02:00, the event takes place any time between 02:00 and 02:15. This prevents several phones from accessing the server at the exact same time.

Firmware Upgrade

Configuration Files

For specific parameters you can set in the configuration files for automatic update, see Appendix A, the section, “Configuration Server Settings” on page A-11.

41-001160-00, Rev 01 Release 2.0 8-7