Agilent Technologies 660MHz manual Use this command to set up the destination segment

	Programming Reference
	SCPI Instrument Command List
Command	:DIG:PATT:LOOP:INF:STAR
Long	:DIGital[:STIMulus]:PATTern:LOOP:INFinite:STARt
Form	Set & Query
Parameter	SEGM1 SEGM2 SEGM3 SEGM4 1 2 3 4
*RST value	SEGM1
Description	Use this command to set up the destination segment.
	The infinite loop is ignored, if :ARM:SOURce is IMMediate
	(CONTINUOUS mode), since in continuous mode there has to be a jump
	back to the start of the pattern (always from segment 4 to segment 1).
Example	See previous example (page 46).

Command	:DIG:PATT:LOOP:STAR
Long	:DIGital[:STIMulus]:PATTern:LOOP[:LEVel[1]]:STARt
Form	Set & Query
Parameter	SEGM1 SEGM2 SEGM3 SEGM4 1 2 3 4
*RST value	SEGM1
Description	Use this command to set the first segment within a counted loop. The
	start of the counted loop must be within the infinite loop (if used).
Example	To set up an infinite loop over segment 2 to segment 4 and a counted loop
	across segment 2 and segment 3:
	:ARM:SOUR EXT1	Set arming source to EXT-IN
	:ARM:MODE STAR	Set arming mode to started
	:ARM:SENS POS	Arm on positive level
	:DIG:PATT:LOOP:INF ON	Switch on infinite loop
	:DIG:PATT:LOOP:INF:STAR SEGM2	Set jump destination to segment 2
	:DIG:PATT:LOOP 100	Set number of repetitions of
		segment2 and segment 3
	:DIG:PATT:LOOP:STAR SEGM2	Set start of counted loop
	:DIG:PATT:LOOP:LENG 2	Set length of counted loop
	:DIG:PATT ON	Switch on PATTERN mode

47