Agilent Technologies E1439 manual Option/fiberMode Off, Append

Agilent E1439 Programmer's Reference

Functions listed alphabetically

headerValuePtr points to the current value of initalValue

incrementCount specifies the number of automatic increments to the headerIndex bit field. The default incrementCount is 0 and the maximum value is (2^10 -1).

Example

The following is a example of how the increment process works.

For headerValue = 0x12345678 and incrementCount = 0x2, the sequence of values for headerValue and headerIndex are:

Increment	headerValue	headerIndex
0	0x12345678	0x278
1	0x12345679	0x279
2	0x1234567A	0x27A
0	0x12345678	0x278
1	0x12345679	0x279
2	0x1234567A	0x27A

	If an incremented header reaches a value where the headerIndex is 0x3FF, the next headerIndex
	will be 0x000, and no carry will be generated to the upper 22 bits of the header.
Note	If the incrementCount is set to 0, incrementing the headerIndex field is disabled.

incrementCountPtr points to the current value of incrementCount

The following table is a summary of valid fiber, epoch setups. Please note that the designation of N/A means that this information is not applicable to this condition. In this case the setting is accepted but ignored. The designation of OK means the setting is accepted and implemented. The designation of NO means do not use this setting with this condition.

Option/fiberMode	Off	Copy1	Raw	Generate	Append
BOF_OFF1	N/A	N/A	OK	OK	OK
BOF_ON2	N/A	N/A	OK	OK3	OK4
CRC_OFF	N/A	OK5	OK	OK	OK5
CRC_ON1	N/A	OK5	OK	OK	OK5
FLOW_CONTROL_OFF1	N/A	N/A	OK	OK	OK
FLOW_CONTROL_COPY	N/A	N/A	OK	OK	OK
FLOW_CONTROL_NO_COPY	N/A	N/A	OK	OK	OK
EPOCH_GEN_OFF	N/A	N/A	OK	OK	NO
EPOCH_GEN_ON1	N/A	N/A	OK	OK3	OK6
HEADER_OFF1	N/A	N/A	OK	OK	OK
HEADER_ON2	N/A	N/A	OK	OK	OK

1.Default instrument setting on power-up and reset.

2.Not applicable unless EPOCH _GEN_ON is enabled.

100