Agilent Technologies E1439 manual Age1439combosetup, Blocksize, Interpolate, Phase, SigBw

Agilent E1439 Programmer's Reference

Functions listed alphabetically

age1439_combo_setup

Combines often used setup commands from various functions.

	age1439_combo_setup sets signal bandwidth, blocksize and center frequency.
	VXIplug&play Syntax
	#include "age1439".h
	ViStatus age1439_combo_setup(ViSession id, ViInt16 sigBw, ViInt32 blocksize, ViInt32
	phase, ViInt32 interpolate);
	Description
	age1439_combo_setup provides a faster way to set up parameters from several functions which
	are often used together.
	Parameters
id	is the VXI instrument session pointer returned by the age1439_init function.
blocksize	See “age1439_data_setup” on page 90 for a description of the blocksize parameter.
interpolate	See “age1439_frequency_center_raw” on page 125 for a description of the interpolate parameter.
phase	See “age1439_frequency_center_raw” on page 125 for a description of the phase parameter.
sigBw	See “age1439_filter_setup” on page 120 for a description of the sigBw parameter.
	Comments
	This command halts the current measurement which also releases the forced Idle state. If you use
	this command in multi-module systems to synchronously change the center frequency while the
	modules are forced to Idle, then you should subsquently call age1439_meas_control to re-assert
	the forced Idle condition.
	Return Value
	AGE1439_SUCCESS indicates that a function was successful.
	Values other than AGE1439_SUCCESS indicate an error condition or other important status
	condition. To determine the error message, pass the return value to “age1439_error_message” on
	page 102.
	See Also
	“Commands which halt active measurements” on page 198, “age1439_init” on page 132,
	“age1439_filter_setup” on page 120, “age1439_frequency_center_raw” on page 125, “age1439_
	data_setup” on page 90, “age1439_meas_control” on page 151

87