Allied Telesis AT-S110, AT-GS950/10PS manual Egress Rate Limiting

Chapter 12: Storm Control

Egress Rate Limiting

This procedure explains how to set Bandwidth levels and Status for

Egress Rate Limiting on each port of the AT-GS950/10PS switch.

To change the settings of the egress rate limiting feature, perform the following procedure:

1.From the main menu on the left side of the page, select the Bridge folder.

2.From the Bridge folder, select Storm Control. The Storm Control folder expands.

3.From the Storm Control folder, select Egress Rate Limiting. The AT-GS950/10PS Egress Rate Limiting page is displayed. See Figure 48 for a partial view of this page.

Figure 48. AT-GS950/10PS Egress Rate Limiting Page

To set the Bandwidth field, enter a number in the range of 1 to 15625.

You can select the ALL row to set all of the ports to the same setting.

Note

See “Egress Rate Limiting” on page 143 for calculating the bandwidth limit set by the Bandwidth field.

4.To enable or disable egress rate filter, select Enable or Disable from the Status pull-down menu next to the port that you want to change. You can select the ALL row to set all of the ports to the same setting.

5.Click Apply.

6.From the main menu on the left side of the page, select Save Configuration to Flash to permanently save your changes.

148