Allied Telesis AT-GS950/10PS, AT-S110 manual Upgrade Firmware Image via Http

AT-GS950/10PS Switch Web Interface User’s Guide

Upgrade Firmware Image via HTTP

This section describes how to upgrade an firmware image of the AT-S110 Management Software using HTTP on an Internet server. Before downloading a new version of the AT-S110 Management Software onto the switch with HTTP, note the following:

The current configuration of the switch is retained when a new AT-S110 software image is installed. To return a switch to its default configuration values, see “Configure Factory Default Values” on page 340.

When downloading the new image file, your switch must have an IP address and subnet mask assigned, either manually or via DHCP. For instructions on how to set the IP address and subnet mask on a switch, see “Configuration of IP Address, Subnet Mask and Gateway Address” on page 30. To enable a DHCP client, see “DHCP Client Configuration” on page 45.

Caution

Downloading a new version of management software onto the switch causes the device to reset. Some network traffic may be lost during the reset process.

This procedure assumes that you have already obtained the software and have stored it on the computer from which you will be performing this procedure.

To download the AT-S110 image software onto the switch using HTTP, perform the following procedure:

1.From the menu on the left side of the home page, select the Tools folder.

This folder expands to show the Firmware Upgrade folder.

325