Allied Telesis AT-S110, AT-GS950/10PS manual Configuration

Chapter 9: Loopback Protection

Configuration

To configure the Loopback Detection feature, perform the following procedure:

1.From the main menu on the left side of the page, select Bridge. The Bridge folder expands.

2.From the Bridge folder, select Loopback Detection.

A partial view of the AT-GS950/10PS Loopback Detection Page is displayed. See Figure 37.

Figure 37. AT-GS950/10PS Loopback Detection Page

3.For the Loopback Detection State field a the top of the page, select one of the following radio buttons:

Enabled: This selection enables the Loopback Detection feature across the switch. This state must be enabled for the individual port Loopback Detection State is effective.

Disabled: This selection disables the Loopback Detection feature on the switch.

120