Allied Telesis AT-GS950/10PS, AT-S110 manual Assign Ports to a Vlan Mode

AT-GS950/10PS Switch Web Interface User’s Guide

Assign Ports to a VLAN Mode

The procedure described in this section allows you to assign ports to tagged or a port-based VLAN. In addition, it permits you to display the current VLAN assignment of ports.

However, you can assign ports to a port-based VLAN only after you have created a port-based VLAN with the procedure described in “Port-Based VLAN Configuration” on page 164.

By default, all of the ports on the switch are assigned as untagged members to the default tagged VLAN with a VLAN ID of 1. The default VLAN is permanent and must have at least one untagged port assigned to it at any time.

To assign ports to a 802.1Q Tagged VLAN or Port-Based VLAN, perform the following procedure:

1.From the main menu on the left side of the page, select Bridge. The Bridge folder expands.

2.From the Bridge folder, select VLAN. The VLAN folder expands.

3.From the VLAN folder, select VLAN Mode.

The VLAN Mode Page is displayed. See Figure 49.

Figure 49. AT-GS950/10PS VLAN Mode Page

4.To add ports to a 802.1Q Tagged VLAN or Port-Based VLAN, select the ports accordingly on the VLAN Mode page.

Note

Before you assign a port as a member of a Port-Base VLAN, you must create the Port-Base VLAN by following the steps defined in “Port-Based VLAN Configuration” on page 164

5. Click Apply.

155