Ampro Corporation P5X manual

Little Board/P5x Technical Manual

!UART2 Mode — configures the second serial port to be a standard serial port or for one of the IrDA modes. Enabling one of the IrDA modes provides access to the IR configuration parameters. Available IrDA modes are HPSIR (standard IrDA), ASKIR (amplitude shift keyed infrared), fast IR, or TTL.

!Onboard Parallel Port — set the parallel port address and IRQ assignments. Available addresses are 378, 278, or 3BC. Available IRQ assignments are IRQ 7 and IRQ5. You may also disable the port.

!Parallel Port Mode — set the parallel port mode.

!ECP Mode Use DMA — selects a DMA channel to use with the ECP mode of the parallel port. This selection only applies if the parallel port is configured for ECP or ECP/EPP modes.

!Onboard VGA Display — selects either CRT, flat panel (FP), or both. In CRT/FP mode the CRT may not display correctly depending on the Flat Panel selected and the scan capabilities of the CRT monitor. On-board VGA display default is CRT/FP.

!VGA Flat Panel Type — There is support for 16 VGA Flat Panel Types, numbered 1 to 16. Contact Technical Support for a list of supported panels.

!Flat Panel Video — select either normal video or reversed video.

!Onboard PCI Ethernet — enable or disable the on-board Ethernet controller.

!Onboard Ultra SCSI — enable or disable the on-board Ultra SCSI controller.

2–77