Switched Rack PDU

USER’S GUIDE

®

An Access option (the Settings option in the control console) enables (by default) or disables SNMP. When SNMP is enabled, the Access Control settings allow you to control how each of the four available SNMP channels is used.

Syslog

By default, the Rack PDU can send messages to up to four Syslog servers whenever System (embedded management card) and Switched Rack PDU (Device) events occur. The Syslog servers, which must be specifically identified by their IP addresses or domain names, record the events in a log that provides a centralized record of events that occur at network devices.

This user’s guide does not describe Syslog or its configuration values in detail. For more information about Syslog, see

See also RFC3164, at www.ietf.org/rfc/rfc3164.

Syslog settings. Leave the Syslog settings, except the Server IP settings, set to their defaults unless otherwise specified by the Syslog network or system administrator.

Setting

 

Definition

 

 

 

General Settings

 

 

 

Syslog

 

Enables (by default) or disables the Syslog feature.

 

 

 

Facility

 

Selects the facility code assigned to the Rack PDU’s Syslog messages

 

 

(User, by default).

 

 

NOTE: Although several daemon-specific and process-specific

 

 

selections are available, along with eight generic selections, User is

 

 

the selection that best defines the Syslog messages sent by a Rack

 

 

PDU.

 

 

 

86

Page 89
Image 89
APC AP7900 manual Syslog