Apple 12/640PS manual Replacing the side cover, Repeat to install the second Simm if necessary

To remove a SIMM, carefully spread the retaining clips at both ends of the installed SIMM, then rotate the SIMM forward until it can be pulled free of the slot.

2Repeat step 1 to install the second SIMM if necessary.

You’ve now installed the expanded memory. You need only replace the side cover to complete the installation.

3Remove and discard the grounding wrist strap.

Replacing the side cover

After installing the memory, you then replace the side cover on the printer and fasten it with the Phillips screws that you removed earlier.

To replace the cover on the printer, follow these steps.

1Line up the front edge of the side cover with the front edge of the printer.

2Gently press the cover into the printer until the tabs snap into their receiving slots.

Place the cover back on the printer

and press firmly until it snaps into place.

Installing Options 157