Note: | The magazine drive gear engages |
| automatically. In case it does not engage |
| properly, turn the magazine drive gear slightly |
| and try again. |
•Check that the magazine is firmly seated.
•Open the movement by turning the inching knob ➪ photo until the mark aligns with the mark on the movement and then turn the movement locking lever ➪ photo towards the “OPEN“ position.
•With your right hand pull the film loop downwards out of the camera ➪ photo. Then push it as far upwards as possible so that the film collapses on the upper film loop. Insert the loop between the movement plate and the film gate.
•Bring the film loop into position ➪ photo.
•Position the film by one perforation hole onto the positioning pin ➪ photo in the film guide, bringing the film loop to rest within the marking ➪ photo.
•Check that the film is correctly fixed on the positioning pin. Check that the loop is positioned within the upper marking, and that the film aligns with the film gate.
loop marking
Camera Body
43