Setting the Film Counter Configuration (Mode 3)

The display configuration can be set individually. The two shown combinations are possible:

The desired display configuration can be set in Mode 3:

•Change from Mode 1 to Mode 3 by depressing the “MODE”-button twice.

•Depress the “SEL”-button twice; the first digit in the upper display line blinks.

•Within three seconds, depress the “SET”-button.

•The currently set counting value of Mode 3 is displayed. The corresponding counting value in Mode 1 is auto- matically altered.

Resetting the Film Counter (Modes 1 and 3)

•Change to the mode which shows the total amount of exposed film (“MODE”-button).

•The total exposed film counter can be set to zero by depressing the “SET”-button (for at least 1.5 seconds) while in standby.

•The take length counter is automatically reset each time the camera is started.

Changing the Unit of Measurement (Meters/Feet) (Mode 3)

•Change from Mode 1 to Mode 3 by depressing the “MODE”-button twice.

•Depress the “SEL”-button once; the symbol m/ft blinks.

•Depress the “SET”-button within three seconds to change the unit of measurement.

Displaying the Angle of the Mirror Shutter (Mode 1)

•As long as the “PHASE”-button is depressed while in standby, the set angle of the mirror shutter appears in the upper display line.

The camera runs at inching speed.

Setting the shutter angle: see Chapter 7.

Camera Operation

59